Description
Key Technical Specifications
| Parameter | Value |
|---|---|
| Manufacturer | GE |
| Model Number | IS200WETBHIB |
| Series | Mark VIe Wind |
| Product Type | WETB board / control circuit board |
| Functional Role | Wind turbine signal interface and control support |
| Board Type | Conformal-coated PCB assembly |
| Application | Wind power generation control systems |
| Environment | Industrial / harsh-duty service |
| Lifecycle Status | Legacy spare / stocking risk |
| Stocking Strategy | Keep 1-2 units on-site for critical assets |
| Condition | New Surplus / New Original |
Product Introduction & Supply Chain Strategy
GE IS200WETBHIB is a Mark VIe Wind board used in turbine control environments where signal integrity and environmental durability matter. It supports the front-end interface between field signals and the turbine control system, so it plays a direct role in reliability and fault response.
Buying this as New Surplus is a practical supply-chain decision for aging wind fleets. It reduces lead time variability, lowers stock-out risk, and gives you a better Total Cost of Ownership than chasing emergency replacements from uncertain sources.
Installation & Configuration Guide
Stage 1: Pre-Installation
Apply lock-out/tag-out and verify the turbine cabinet is safe to open. Use an ESD strap, insulated tools, and a camera to document the board, connector positions, and cable routing before removal. Confirm the replacement model and revision match the installed unit.
Stage 2: Removal
Disconnect all wiring carefully and remove the board straight out of the rack. Avoid flexing the PCB or stressing the backplane connector. Inspect the slot, pins, and cabinet interior for contamination, corrosion, or heat damage.
Stage 3: Installation
Install the replacement board in the same slot and reconnect each cable exactly as documented. If the assembly uses any jumpers or board-specific configuration, duplicate them precisely. Seat the board fully before tightening any retaining hardware.
Stage 4: Power-On & Testing
Before energizing, check supply rails and verify there are no shorts on the connected circuits. Power up and confirm normal board status and communication with the control system. Validate turbine I/O response and clear faults only after the system is stable.
- IS200WETBHIB
- IS200WETBHIB
Firmware/Software Versions & Upgrade Notes
This board is primarily a hardware interface assembly, so software risk is usually tied to the wider control system rather than the card itself. The important compatibility points are Mark VIe Wind cabinet revision, system configuration, and any board-specific mapping in the application.
Do not mix firmware or logic changes into the replacement job unless the site has already validated that path. For urgent swaps, matching the installed configuration is the safest route.
Frequently Asked Questions
Is this really New Surplus? Yes. The correct sourcing position is New Surplus / New Original, meaning genuine OEM inventory rather than a rebuilt or repaired unit.
Why is the price lower than OEM new but higher than lower-cost listings? New Surplus usually comes from excess inventory. It keeps OEM origin and lower lifecycle risk without full OEM list pricing.
Is IS200WETBHIB obsolete? Treat it as a legacy Mark VIe Wind spare with lifecycle risk. For critical turbines, keep buffer stock and plan for last-time-buy coverage.
Can I hot-swap it? Do not assume hot-swap capability. Isolate the cabinet first to avoid faults or communication loss.
Will the program transfer automatically? No. Document wiring, connector positions, and any board-level settings before removal so the replacement can be restored correctly.
What warranty should I expect? New Surplus industrial spares typically carry limited supplier warranty coverage, often 1 year depending on source and contract terms. Confirm the exact warranty before purchase.
Start Chat
